Page 41 of 91
© Retrotec 2017
4.8 Set up “Network” if using Ethernet connection
1. From the Home screen, tap [Settings] and then the […] key to get to the second “Settings” screen
2. Tap the [Network] key to enter the Network Settings menu.
3. From the “Network settings” screen, tap the [Status] key to cycle through different connection
types available between the gauge and the computer:
• “Disabled” (neither wired Ethernet nor WiFi network being used)
• “Wired” (Ethernet cable connected to the gauge)
If WiFi is enabled on your DM32, you will also see choices for:
• “WiFi-Create” to turn on the WiFi hotspot for phones and computers to find
• “WiFi-Join” to let the DM32 join an existing network
For information about using the gauge with a “Network” and for detailed instructions about further
settings required, refer to Section 5.
The “Status” should be set as “Disabled” if the gauge will be connected to the computer with a USB cable,
since this direct connection does not involve a network. If the USB cable is just being used for charging the
battery, the [Network] settings do not need to be changed.
Figure 48: Choose Disabled or Wired for the gauge Network connection
To Next Page
Loading...
Need help?
General
