Retsch AS200 - Signal at Conclusion of Sieving; Intermittent - Continuous Operation

21.11.2001  Retsch GmbH 16 Doc. No E98.014-016.9999 A
Signal at conclusion of sieving
Fig. 3
If the sieving process runs to completion without
interruption, the conclusion will be announced with five
signal tones.
Disabling the signal: Fig. 3
* Press buttons S and X simultaneously
A tone will sound to confirm the entry.
Enabling the signal: Fig. 3
* Press buttons S and W simultaneously.
A tone will sound to confirm the entry.
Intermittent – Continuous operation
Fig. 4
Intermittent operation is initially disabled when the
AS200 is first switched on.
Enable intermittent mode, 1 to 99 sec.: Fig.
4
* Press button R.
* The LED above button R lights.
* Display O shows “10 sec”.
* Pressing button Q will raise the interval period up to as
much as 99 sec.
When the 99 sec. value is exceeded, the display will
cycle back to 1 sec. and continue from there.
* Pressing button P reduces the interval period, down to 1 sec.
When the 1 sec. value is exceeded, the display will cycle
back to 99 sec. and continue from there.
Disable intermittent mode: Fig. 4
* Press button S.
* The LED above button S lights.
* Display O goes out.