Retsch AS200 - AS200 Digit Model Operation

21.11.2001  Retsch GmbH 19 Doc. No E98.014-016.9999 A
Operation for the AS200 digit
Switching on and off
The main switch J is located at the left-front on the AS200; see
Fig. 8
* Turn the main switch on.
* The interval off LED lights, Fig. 9
* Two bars light in the time display, see Fig. 9
The AS200 is now ready for operation, without the interval
function, in continuous duty.
Fig. 8
Start - Interrupt - Stop
Fig. 9
Start: Fig. 9
* Press the START button W1.
* The green LED above button W1 lights.
Interruption (pause function): Fig. 9
* Press the STOP button X1 once.
* The red LED above button X1 lights.
* Sieving is suspended; values remain visible in the
display.
* Press the START button W1.
* The sieving process will be resumed.
Stop (standby function): Fig. 9
* Press the STOP button X1 twice
* Red LED above button X1 lights.
* The entire display goes out.
* Activate the LED displays: press button W1 once.
* New values can now be entered.
* Press the START button W1 a second time
* The same function will be executed as with the start
function.