21.11.2001 Retsch GmbH 9 Doc. No E98.014-016.9999 A
Electrical connection
* Refer to the data plate for information on the voltage and
frequency at which the AS200 is to be operated.
* Ensure that the values shown there correspond to those for the
local power supply.
* Use the supplied power cord to connect the AS200 to the
power supply.
* When connecting the power cord to the power source, be sure
that the supply circuit is fused in accordance with local codes.
Failure to observe the values on the data plate
can cause damage to either the electrical or the
mechanical components or both.
To Next Page
Loading...
