21.11.2001 Retsch GmbH 32 Doc. No E98.014-016.9999 A
!
Never place the AS200 directly in a basin for
operation.
Fatal electrical shock hazard.
!
During wet sieving always connect the AS200 to a
socket which is protected by a ground fault
interrupter.
Adjust the volume of water applied so that it will just
wet the surface of the screen.
Water backing up in the sieve stack can cause
overloading and thus may damage or destroy the
sieve weave.
The loading capacity charts provided in the
Appendix to these operating instructions are not
applicable to wet sieving.
Due to the difficulty in defining the volume of water in the
sieve stack, it is impossible to make reliable statements
for wet sieving.
To Next Page
Loading...
