INSPIRE Quick Start Guide
©2023 REVOPOINT 3D ALL RIGHTS RESERVED 14
4. What to do if the object you want to scan isn't clear in the
preview window?
Increase the brightness in Revo Scan till the object looks clearly defined
and has as few red and blue patches in the preview window as possible.
5. What to do if your scanned model’s surfaces lack detail or the
details are smeared?
Unfortunately, you’ll need to redo the scan, but be careful to only scan
an area once rather than multiple times. Basically, the smaller the
number of frames, the better the scan quality. Scanning the same spot
twice will only lower the detail.
6. What to do if you keep running out of memory when scanning?
The object you’re scanning is too large for your computer or
smartphone’s amount of RAM. If this happens, pause the scan, fuse the
model, and start a new scan from where you had to pause your
previous scan. These separate scans can be merged together in Revo
Scan V5 to make a whole model once you’ve finished scanning the
object.
7. What should I do if the firmware upgrade fails and the LED light
keeps showing blue?
Connect your INSPIRE to a power source, then press the Start/Pause
button 10 times continuously to restore the scanner to the normal
scanning mode.
Customer Service
If you need any assistance with your scanner, please don’t hesitate to
contact us at customer@revopoint3d.com or drop us a line at +1 (888)
807-3339 or chat with one of our customer service agents online on our
website at www.revopoint3d.com. Click the speech bubble on the
bottom right corner of the screen.
To Next Page
Loading...
