19
①
Tap the icon to choose Accuracy, Tracking Mode, and Object Type. Toggle Color Scanning if
you need a color model.
②
Move the scanner closer or further away from the object until the scanning distance indicator bar
shows Excellent or Good.
③
Tap the button for the Depth Cameras’ exposure to be set automatically, or you can turn off
the exposure and change the exposure by dragging the slider until there are as few blue
and red areas on the object in the Depth Camera preview window as possible.
④
You also must adjust the RGB Camera’s exposure when doing a color scan. Tap the button
for the exposure to be set automatically, or you can turn off the exposure and adjust the
exposure by dragging the slider until the object’s color in the RGB preview window is clear and
sharp.
⑤
Tap the button to start your scan. While scanning, hold the scanner steady and move slowly.
Try not to scan the same areas repeatedly.
⑥
Tap the button to finish the scan and enter the post-processing window when the scan is over.
To Next Page
Loading...
