REVV | D25
16
FOOT CONTROLLER
& COMPLIANCE
CONTROL MODE
43
The D25’s Gain Boost & Reverb may be enabled &
disabled independently via the included 2-button
footswitch. This connects to the rear of the amplifier
with the included 5 PIN DIN cable. When Foot Switch
is connected, the Gain Boost button on the front panel
is bypassed.
COMPLIANCE FOR USA
44
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired
operation. This equipment complies with FCC
radiation exposure limits set forth for an uncontrolled
environment. End-users must follow the specific
operating instructions for satisfying RF exposure
compliance. This transmitter meets both portable
and mobile limits as demonstrated in the RF Expo-
sure Analysis. This transmitter must not be co-located
or operating in conjunction with any other antenna
or transmitter except in accordance with FCC multi-
transmitter product procedures.
COMPLIANCE FOR CANADA
45
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause
interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device. Under Industry
Canada regulations, this radio transmitter may only
operate using an antenna of a type and maximum (or
lesser) gain approved for the transmitter by Industry
Canada. To reduce potential radio interference to
other users, the antenna type and its gain should be so
chosen that the equivalent isotropically radiated power
(e.i.r.p.) is not more than that necessary for successful
communication.
To Previous Page
Loading...
