REVV | D25
13
MIDI
SETUP
35
Versatile & optional MIDI control helps Revv amps
seamlessly integrate into any rig. The amplifier will store
up to 128 programs for program change commands as
well as accept Continuous Controller (CC) commands
to control functions directly. The amplifier also features
OMNI mode to allow control options on 16 channels, &
phantom power to power control devices.
PROGRAM CHANGE
36
Each preset on the D25 has a single program number.
Preset 001 is recalled with MIDI PC 1, and you can recall
the 128 virtual cab presets with MIDI PC 1 through MIDI
PC 128 in this manner.
CONTROL CHANGE
37
For particular uses, Control Change signals may be
appropriate. We recommend starting with PC signals
(virtual cabinet preset recall) for the D25 and then only
moving on to CC signals for particular and advanced
situations.
MIDI CC COMMANDS
38
The following table indicates the Control Change numbers
for every parameter and their range and behavior. This
table is valid for firmware version
SIMULATION & IR LOADER MODES
39
Parameter CC# Range Behavior
Power Amp
On/O 0 0-1 0 = O ; 1 = On
Model 1 0-7 0 = Model #0 ; 1 = Model #1…
Volume 2 0-30 0 = 0dB ; 30 = 30dB
Presence 3 0-127 0 = 0% ; 63 = 50% ; 127 = 100%
Depth 4 0-127 0 = 0% ; 63 = 50% ; 127 = 100%
Type 5 0-1 0 = Triode : 1 = Pentode
Miking
On/O 6 0-1 0 = O ; 1 = On
Cab 8 0-x 0 = Cab #0 ; 1 = Cab #1…
File A 9 0-x 0 = File #0 ; 1 = File #1…
File B 10 0-x 0 = File #0 ; 1 = File #1…
Folder A 11 0-3 0= User 0 ; 1= User1; 2 = User 2 ; 3 = User 3
Folder B 12 0-3 0= User 0 ; 1= User1; 2 = User 2 ; 3 = User 3
Mic A 13 0-7 0 = Mic #1 ; 1 = Mic #1…
To Next Page
Loading...
