Getting Started
Quick Start
22
© 2018
REXING
A
ll Rig
hts
Re
s
er
v
ed
.
Charging the battery
Charge the device by connecting the camera via the car charger port. Use only
Rexing-approved chargers. Using unapproved chargers or cables can
damage the device or cause the battery to explode.
Connect the car charger’s jack to the charging port, and then plug the charger
into the car cigarette lighter or 12V DC power outlet. Press the button on the
charger, make sure the power LED is ON.
• Battery is mainly used to save files in emergency. Please always
connect Rexing V1LG to external power while it is in use.
• When device detects no power supply, it will automatically power off
after 5 seconds. To turn on the device again, you will need to do so
manually by pressing the ON / OFF button.
• If the battery is completely discharged, the device will not turn on
immediately when the charger is connected. Allow a depleted battery
to charge for a few minutes before attempting to turn on the device.
• The device can be used while it is charging, although it may take
longer to fully charge the battery.
• If the device receives an unstable power supply while charging, the
screen may not function properly. If this happens, unplug the charger
from the device.
• While charging, the device may heat up. This is normal and should
not affect the device’s performance or lifespan.
• If the device is not charging properly, take the device and the charger
to an authorized Rexing Service Center.
• Rexing V1LG can ONLY powered by 12V Charging port. You can
NOT charge unit via USB port.
To Next Page
Loading...
