Getting Started
Installation
8
If the device receives an unstable power supply, the screen may not
function properly. If the device is not operating properly using a Rexing-
approved charger, please contact Rexing Customer Care
(care@rexingusa.com
).
3.2 Formatting the Memory Card
Before formatting your memory card, always remember to make backup
copies of all important data stored on the card. The manufacturer’s
warranty does not cover loss of data resulting from user actions.
Note: It’s recommended that you format your memory card after
transferring files to your computer or at least once a month. For best
results, format the memory card using the Format function on your
camera:
a. Upon turning on the camera, press the OK button to stop recording.
b. Press the MENU button twice to enter the System Setup Menu.
c. Use the UP and DOWN navigation buttons and toggle to the “Format”
option.
d. Press OK to confirm your selection.
e. You will be notified that all data will be deleted. Scroll down to “OK” and
press the OK button to confirm.
f. If you followed the instructions above, you should see a blue box asking
you to please wait while the card is being formatted. Formatting should only
take a moment, and you will be taken back to the Setup Menu once
formatting is complete.
g. At this point, disconnect from the power source. The camera will shut down
automatically after 3 seconds. The next time the camera is connected to
power, the camera should start up and begin recording automatically.
To Next Page
Loading...
