Introduction
WARRANTY — Rexnord Industries (the “Company”) warrants
that, for a period of three years from the date of shipment, the
product described herein will deliver successfully its rated output
as indicated on the nameplate, provided, it is properly installed
and maintained, correctly lubricated, and operated in the
environment and within the limits of speed, torque or other load
conditions for which it was sold. Such product is expressly not
warranted against failure or unsatisfactory operation resulting
from dynamic vibrations imposed upon it by the drive system in
which it is installed unless the nature of such vibrations has
been fully defined and expressly accepted in writing by the
Company as a condition of operation.
WARNING: Consult applicable local and national safety codes
for proper guarding of rotating members.
Lock out power source and remove all external loads from drive
before servicing drive or accessories.
CAUTION: Do not weld the drive housing or accessories
without prior approval from Rexnord Geared Products. Welding
on the drive may cause distortion of the housing or damage to
the bearings and gear teeth. Welding without prior approval will
void the warranty.
DRIVE RATING — Operate the drive only within the
horsepower and output speed for which it was selected and
specified in Selection Guide 371-110 for the application. Refer
to the nameplate for drive size, ratio, and data.
FACTORY REPAIR AND REBUILD — Falk/Renew wants to
continue to be your primary supplier, and extend our service to you
if your equipment is in need of repair or replacement.
We are able to furnish a fast turn-around on both the quotation
and rebuild. Nobody can do the job better than Falk. If you
need repair on Falk products . . . just ask.
Contact your local Rexnord account executive or Rexnord-Falk
Distributor for more information.
Rexnord Industries, LLC 3001 W. Canal St., Milwaukee, WI 53208-4200 USA378-200 (PN-2128394)
Telephone: 414-342-3131 Fax: 414-937-4359November 2010
e-mail: info@rexnord.com web: www.rexnord.comSupersedes 6-07
Shaft Mounted Drives Model A
(Page 2 of 44) Sizes 5107-5315
To Next Page
Loading...