REXROTH EFC5610 User Manual

Bosch Rexroth EFC5610 Frequency Inverter
Easy Start Guide
This guide is intended to complement the user manual provided by the manufacturer.
It is provided as a basic introduction to the product for Inverter Drive Supermarket customers.
It should not be used as a replacement for the manual issued by the manufacturer.
Issue 1
20180705
This product is not a safety device. All safety considerations including but not
limited to Emergency Stop provision should be assessed separately and are
outside the scope of this guide.
The Bosch Rexroth EFC5610 Frequency Inverter range
is available to order from inverterdrive.com
L1 L2 L3 (+) B U V W

REXROTH EFC5610 Specifications

General

Supply voltage	24 VDC
Rated current	10 A
Control mode	Field-oriented control (FOC)
Analog outputs	2
Input Voltage	24 VDC
Control Type	Field-oriented control (FOC)

Summary

Parameters to set before use

How to set a Parameter value

Find Parameter Groups

Steps to find parameter groups by pressing the 'Func' key repeatedly.

Find a Parameter Group eg. E0

Identifies parameter groups and how to select one using the 'Set' key.

Find a Parameter eg. E0.26

Navigates to a specific parameter within a group using up/down keys.

Change a Parameter value

Explains how to adjust parameter values using up/down keys and save with 'Set'.

How to operate the Inverter from the keypad

Use the dial to set the required speed

Describes setting the speed reference using the keypad dial.

Press the green “Run” button to start the motor

Instructions for starting the motor using the green 'Run' button.

Press the red “Stop” button to stop the motor

Instructions for stopping the motor using the red 'Stop' button.

How to enable Sensorless Vector Mode

Parameters to check prior to an Autotune

Start Autotune

The Autotune process

How to connect and configure a Potentiometer for remote speed control

Relevant parameters for remote Potentiometer speed control

Connecting the Potentiometer

How to connect and configure a Run Forward or Run Reverse switch

Connecting the Switch

How to connect and configure a Run/Stop switch with Forward/Reverse selection

Relevant parameters for remote Run/Stop

How to configure "3-Wire" control with Run/Stop pushbuttons and Forward/Reverse selection

Relevant parameters for remote 3-wire control

Connecting the Switches

How to reset the Inverter to Factory Defaults

Select the b0 Parameter Group

Select Parameter b0.10

Change value of b0.10 from 0 to 1

Finished