Easy Start Guide
Page 1
This guide has been produced by The Inverter Drive Supermarket Ltd.
All content, including but not limited to graphics, text and procedures copyright The Inverter
Drive Supermarket and must not be reproduced or altered without prior written permission.
©
Page 1
Page 3
Page 4
Page 5
Page 2
Page 12
Page 8
Page 13
Page 10
Page 6
Page 14
Page 7
Page 15
Page 11
Page 9
How to connect and configure a Run Forward or
Run Reverse switch
Motor Connections - Star and Delta
How to enable Sensorless Vector control
Parameters - Overview
How to set a Parameter value
Power and Motor Connections (Three Phase)
How to Operate the Inverter from the keypad
STO (Safe Torque Off) Connections
How to connect and configure a Potentiometer
for remote speed control
Contents
Power and Motor Connections (Single Phase)
Parameters to set before use
How to connect and configure a Run/Stop switch
with Forward/Reverse selection
How to configure “3-Wire” control with Run/Stop
pushbuttons and Forward/Reverse selection
Brake Resistor Connection
How to Reset the Inverter to Factory Defaults
Contents
Bosch Rexroth EFC 5610 Series Inverter
To Next Page
Loading...
Need help?
General
