Reyee RG-E6 - 4 Debugging; 4.1 Setting Up the Configuration Environment; 4.2 Powering On; 4.3 Troubleshooting Power Failures

To Next Page

To Previous Page

Hardware Installation and Reference Guide Debugging

13 techsupport@ireyee.com

4 Debugging

4.1 Setting Up the Configuration Environment

Verify that the power cables are in good condition and meet safety requirements.

4.2 Powering On

4.2.1 Checking Before Power-on

Verify that the DC power cord connector of the device is in good condition, and that the device does not shake

when the DC power adapter is connected to the DC power cord connector.

4.2.2 Checking After Power-on

 Verify that the LED status is normal.

 After the device is powered on, verify that the SSID can be successfully connected to by a smartphone or

any other wireless device.

4.3 Troubleshooting Power Failures

The working status of the LED on the device indicates whether the device power supply system is malfunctioning.

See 错误!未找到引用源。错误!未找到引用源。 for the description of the LED status. Perform the following

checks in the case of any abnormality:

 Verify that the device is properly powered on.

 Verify that the Ethernet cable is correctly connected to the device.

Note

If the device still cannot be powered on after the preceding check, please email us at

techsupport@ireyee.com.