Your controller is menu driven. By selecting a menu, you can perform many functions!
TO SEARCH
• Press the Power button
o Displayed will be the....
▪ System configuration (software configuration)
• SHAW (Triple Satellite xKu LNB)
• DIRECTV (SWM 3 LNB)
• DISH NETWORK (Triple Satellite 1000.2 LNB or Hybrid Triple LNBF
Hopper 3)
• BELL TV (Triple Satellite 1000.2 LNB)
▪ Version of software will be displayed i.e. yy/mm/dd
▪ Options are accessed by pressing "SELECT" or POWER button the second
time to enter the menu options. To navigate through the options press
either the SEARCH (UP arrow) or STOW (DOWN arrow)
TO ENTER MENU OPTIONS
• Press the Power button again after turning ON the power to enter the "menu" portion of
your system.
o Press the Up and Down arrows to help you navigate through the menu. Once the
portion of the menu that you want is displayed, press SELECT (POWER button) to
"select" that option....
• 1: Shutdown - will turn OFF your controller
• 2: Search - will direct the mount to search for your specific
satellite that is specified in your system configuration -If deploying
your dish, this process will take approximately 4-4 ½ minutes
before it will “lock” onto the satellite and you can begin watching
your programming
• 3: Stow - will cause the mount to return to its travel position
• 4. Set Position (Technical Support Menu)
• 5: Set Trigger (Technical Support Menu)
• 6: Move Azimuth - pressing and holding the appropriate button
will manually move your mount in azimuth (Up arrow CLOCKWISE,
Down arrow COUNTERCLOCKWISE)
To Next Page
Loading...
