IKONIC Tankless Water Heater Service Manual
23
GENERAL INFORMATION
1.6.4 NETWORK INSTANCE
1. Press the “ SETTINGS ” button.
2. Press the “ ▼ ” or “ ▲ ” button until “Network in-
stance” is displayed, and press " ENTER " button
to confirm.
3. The factory setting is " 1 ". Press the “ ▼ ” or “ ▲
” button to select "1" to "20" for each water heater,
and press "ENTER" to confirm. To exit this setting,
press "BACK" button until the initial screen is dis-
played.
1.6.5 TANKLESS
CONFIGURATION
This section is applicable for pump built in models,
and standard models with an external pump following
the pump installation described in this Use and Care
manual. If the external pump is installed independently
from the water heater, this section is not applicable. For
recirculation setting, timer mode, schedule mode, and
on demand mode are available. Timer mode also has
Performance mode and Energy Saver mode. Read next
several pages to set most suitable mode. Contact ser-
vice department if additional help is needed.
1.6.5.1.1 TIMER MODE
1. Press the “ SETTINGS ” button.
2. Press the “ ▼ ” or “ ▲ ” button until “Tankless Con-
fig” is displayed, and press “ENTER” button to con-
firm.
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
120
°F
SETTINGS
BACK ENTER
STATUS SERVICE MODE
120
°F
SETTINGS
BACK ENTER
STATUS SERVICE MODE
115
°F
Press button
to access
“SETTINGS”
Menus
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Network Instance
SETTINGS
BACK ENTER
STATUS SERVICE MODE
10
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
To Next Page
Loading...
