Rheem Iconic RTGH-SR11i - Manual Operating of Recirc. Pump (for Demand)

IKONIC Tankless Water Heater Service Manual
26
GENERAL INFORMATION
4. The Factory setting is "None.” Press the “▼” or
“▲” button until “Schedule” is displayed, and press
“ENTER" to confirm. To exit this setting, press
"BACK" button until the initial screen is displayed
displayed.
NOTE: To use this schedule mode, Wi Wi-Fi is
required on this user interface. The specific
application should also be downloaded to
your smart phone. Please see "Wi Wi-Fi Set-
ting" in the U&C manual to set Wi Wi-Fi on
this user interface and to download the appli-
cation.
1.6.5.2 MANUAL OPERATING
OF RECIRC . PUMP (FOR ON
DEMAND)
On demand mode allows the user to turn ON the recir-
culation pump manually.
1. Press the “ SETTINGS ” button .
2. Press the “ ▼ ” or “ ▲ ” button until "Tankless Con-
fig." is displayed, and press the " ENTER " button.
If incorrect setting is entered at any steps, press
the " BACK " button until the initial screen. Redo
from step 1.
3. Press the “ ▼ ” or “ ▲ ” button until "Recirc . Pump"
is displayed, and, press “ENTER” to confirm.
4. The Factory setting is “Disabled”. Press the “▼”
or “▲” button until "Enable" is displayed and
press the "Enter" button. To exit the setting, press
"BACK" button until the initial screen is displayed.
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Schedule
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE SETTINGS
BACK ENTER
STATUS SERVICE MODE
Tankless ConfigSET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
SETTINGS
BACK ENTER
STATUS SERVICE MODE
None
SETTINGS
BACK ENTER
STATUS SERVICE MODE
OFF
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Recirc.Pump Modes
SET POINT
SETTINGS
BACK ENTER
STATUS SERVICE MODE
Enable