To Next PageTo Next PageWhat causes fluctuating head and vapor pressures in my Rheem Heat Pump?
Fluctuating head and vapor pressures in your Rheem Heat Pump can be due to TXV hunting. Check the TXV bulb clamp and air distribution on the coil, and replace the TXV if necessary. Air or noncondensibles in the system can also cause this issue, so recover the refrigerant, evacuate, and recharge the system.
What causes a gurgling or pulsing noise at the expansion device or liquid line in my Rheem Heat Pump?
A gurgling or pulsing noise at the expansion device or liquid line in your Rheem Heat Pump is caused by air or noncondensibles in the system. To fix this, recover the refrigerant, evacuate, and recharge the system.
General| Type | Heat Pump |
|---|---|
| Refrigerant | R-410A |
| Compressor Type | Single-Stage |
| Warranty | 10-year limited warranty |
| Stages | Single-Stage |
Safety warnings about installation, grounding, power, and R-410A system precautions.
Guidance on tubing installation, line sizing, and oil adjustments for long line sets.
Proper methods for tubing connections, leak testing, and insulation of refrigerant lines.
Procedures for initial start-up, including crankcase heater and airflow verification.
Detailed steps for system evacuation and leak testing to ensure system integrity.
Procedures for checking, weighing, and adjusting refrigerant charge using subcooling.
