The alarm panel is now stay armed
If the Quick Stay Arm feature is enabled, you can skip Step 1 and simply press the STAY key.
Stay Arming with the Remote Control
To stay arm your alarm system using the remote control, please proceed as follows:
Press the STAY button on
the remote control
The status lamp on the remote
control will flash YELLOW and
the stay armed tone will sound
The panel will arm in stay 1 mode
when using a remote
Panic Alarm
The remote control has a panic alarm button which can be pressed at any time to generate a
panic alarm.
Press the PANIC button on
the remote control
The status lamp on the remote
control will flash RED and the
remote will beep
If using the keypad:
Press the PANIC button on
the keypad
Disarming the System with a Remote Control
When the system is away armed, you must enter the protected area via the designated entry
route normally the front or back door. On entering the premises, the entry timer and entry tone
starts. You must press the disarm button on your remote control before the entry timer expires.
To disarm your alarm system during normal entry, please proceed as follows:
Press the DISARM button on
the remote control
The status lamp on the remote
control will flash GREEN and a
single ‘bleep’ tone will sound
Rhino 232 User Manual 9 |