SECTION II: INST ALL ATION AND MAINTEN ANCE
25
II SECTION II: INSTALLATION AND
MAINTENANCE
II.1 TRANSPORT INSTRUCTIONS
II.1.1 PACKAGING AND COMPONENTS
DANGER !
DO NOT OPEN OR T AMPER W ITH THE
PACKAGING UNTIL THE TIME OF INST ALLATI ON.
The units must only be moved and lifted b y
specialised p ersonnel who are trained to do so.
Upon deli ver y, c hec k that t he unit has n ot bee n damaged during
transport and that it is complete with all its parts.
If there is visible da mag e, immediat el y t ake not e o f t he damage and
write t his o n t he tr ansport d ocu ment toget her with the follo wing
statement: “ACCEPTED WITH RESER VATIONS BECAUSE OF
EVIDENT DAMAGE TO THE PACKAGING”, stating the serial number if
there are s everal mac hines , sinc e ex- wor ks deli ver y implies entitlement
to co mpens ation und er the t erms of t he i nsura nce, in acc ordance wit h
the pro visions of ap plicabl e Laws .
To remov e the pa ck aging, follo w the se instructions:
• Chec k f or visibl e damage;
• Ope n th e pac kaging ;
• Verify th at t he envelo pe c ont aining t he use an d main tenanc e manual
is presen t;
• Dispose of t he pac kaging mat erial in accord anc e with c urrent
leg islation, at t he ap propriat e wast e rec epti on or rec ycling site.
SAFE GUARD THE EN VIRONMENT !
Dispose of the p ac kaging m ateri als in compl ianc e
with the n ational or local legislation applicable in
your countr y.
DANGER !
Do not leave the packaging within reach of children.
II.1.2 HANDLING INSTRUC TIONS
DANGER !
Movement of the unit must be performed with care,
in order to av oid dam age to the ext ern al st ruct ure
and to t he internal me chanic al and el ectri cal
components.
Also ma ke sure that ther e a re no obst acl es or
people blocking the route, to avoid the danger of
collisions, crushing or tipping over of the lifting
dev ice. Al wa ys us e the p ersona l protective
equipment.
All the op erations liste d b elo w must be carried out in accord anc e with
current healt h and saf et y reg ul ations , with re fere nce to t he eq uip ment
used as well as t he proce dures follo wed. Bef ore c ommencing handling
opera tions , e nsure that t he lifti ng de vice h as th e required ca pacit y f or
the unit i n questi on.
The units can be moved or lifted by hand or by means of a suitable
truck. If the unit weig hs more th an 30 kg and is to be h andl ed manually,
this must be c arried out by t wo persons: however, it is recommen de d t o
use a truc k. If s e veral units need to be moved at th e sa me time, it is
advisable t o p ut t he machines in a c ont ainer and lift t hem b y mea ns of a
forklift truck or similar means.
II.1.3 STORAGE CONDITIONS
Pac kage d u nits can be st ored by s tac king a ma ximum of four on top of
each ot her a nd must be s tore d in a dr y area.
II.1.4 CLEARANCES AND POSITIONING
IMPORTANT !
Incorrect positioning or in stallation of the unit can
amplif y noise levels and vibrations generated
during operation.
Never obs truct the air flow or return:
MAX 3 m
Prev ent
direct s olar radi ation int o t he roo m (draw t he c urtains) wh en
opera ting in cooling mode:
MAX 3 m
Do not
place t he unit cl ose t o heat sources:
Av oid
enviro nments wit h oil vap ours.
Do not use
a c ondens at e drai n pi pe t o t he ci vil dr ains/se wer wit hout a
siphon. Th e height o f t he si phon must b e acc ording to the water h ead,
which allows the condensate to evacuate correctly.
To Next Page
Loading...