Windows NT 4.0
27
1
❖
❖❖
❖ “Eco. Mode”
When set to “On”, the amount of ink consumption is reduced.
❖
❖❖
❖ “Speed Select”
You can select the printing speed.
❖
❖❖
❖ “Skip Feed”
• Use to make the interval between paper feeds longer, allowing the ink
to dry.
• Use to print paper longer than the standard size.
Limitation
❒ The maximum length of paper that can be printed using Skip Feed is
460mm. However, when printing on paper longer than 432mm, the de-
livered paper may fall off the paper delivery end plate. Therefore, you
should hold the paper so that it does not fall off.
❖
❖❖
❖ “Job Separator”
When set to “On”, classifying will occur whenever the document data
changes.
❖
❖❖
❖ “Sort”
When set to “On”, it is possible to deliver each print set in page order into
the optional sorter.
❖
❖❖
❖ “Rotate”
When set to “180°”, the image will be rotated 180 degrees and printed. This
is very convenient when printing on envelopes. ⇒ p.31 “Printing onto en-
velopes”
❖
❖❖
❖ “Color Separation”
It is possible to output only the color selected from Cyan, Magenta, Yellow,
and Black. If “No” is selected, separation will not be done.
[Job Log] Tab
This tab is used to adjust the settings for plug-in modules. The plug-in modules
are modules that provide additional functions that cannot be implemented by
the printer driver or PPD file.
Limitation
❒ These functions cannot be accessed from applications that use their own
printer driver, such as PageMaker, etc.
Note
❒ The settings adjusted using this tab are used until the values for the settings
are adjusted again.
To Next Page
Loading...
