Error & Status Messages on the Control Panel
19
3
Printer HDD Error.
Press [Reset] to cancel cur-
rent job.
A Printer HDD error is detect-
ed while a macro or font is be-
ing downloaded from the host
to the printer controller.
Press [Reset] to cancel the cur-
rent job.
If the error message often ap-
pears, change the Printer HDD.
Contact your sales or service
representative.
Printer HDD is full.
Press [Reset] to cancel cur-
rent job.
A Printer HDD becomes full
while downloading a macro or
font from the host to the printer
controller.
Press [Reset] to cancel the oper-
ation.
When a length of time passes
without any key pressed, the
operation will be canceled auto-
matically.
To execute the operation cor-
rectly, make room on the disk
partition in advance.
Ready The printer is Online and ready
to make a print.
If you want to change to Offline
mode, press [Offline].
The disk could not be for-
matted.
The hard disk has not been for-
matted successfully.
Turn the main switch off and
back on, and then try format-
ting again.
If this message appears again,
change the hard disk. Contact
your sales or service representa-
tive.
The disk was formatted
successfully.
Turn machine off then on
again to restart.
The hard disk has been format-
ted successfully.
Turn the main switch off, and
then back on.
The hard disk is ready to use.
The Job has been reset. The current print job has been
reset.
*** is not available.
Select another tray and
press [Continue],
or press [
Reset
] to cancel
current job.
Something is wrong with the
selected input tray.
Select another tray to print by
pressing one of the trays dis-
played on the screen or press
[Reset] to cancel the current job.
When a length of time passes
without any key pressed, the
print job will be canceled auto-
matically.
***: Input tray
*** is not set correctly.
Set *** correctly.
The selected input tray is not
set correctly.
Close the selected input tray,
and the print job will be re-
sumed automatically.
***: Input tray
Messages Description Comments
To Next Page
Loading...
