Installing Options
52
3
D Fully insert the 802.11b interface
unit.
E Tighten the two screws to secure
the interface unit.
F Attach the antenna to the card
with the label facing down and
the uneven side of the antenna
facing up.
G With the antenna and indented
end toward you, slowly insert the
interface card until it stops.
H Hold the antenna cap with the cut
off corners towards you and fit it
over the card.
Note
❒ After finishing installation, you
can check the 802.11b interface
unit is properly installed: Print
the configuration page from the
“List/Test Print” menu. If it is
installed properly, you will see
“IEEE 802.11b” for “Controller
Option”.
❒ If the 802.11b interface unit is not
installed properly, reinstall it
from step
A
. If you cannot install
it properly even after attempting
reinstallation, contact your sales
or service representative.
Reference
For printing the configuration
page, see p.30 “Test Printing”.
AET094S
AET095S
AET096S
AET097S
AET098S
GaiaP1GB_Setup-F4_FM_forPaper.book Page 52 Friday, June 3, 2005 7:50 AM
To Next Page
Loading...
