Attaching IEEE 1394 Interface Board Type B
49
3
Attaching IEEE 1394 Interface Board Type B
CAUTION:
Important
❒ The 1394 interface board uses “IP
over 1394” and “SCSI print”. Oper-
ating system-compatible connec-
tion methods are as follows (IEEE
1394 cannot be used with Win-
dows 95/98 and Windows NT 4.0):
•Windows Me
“IP over 1394”
• Windows 2000
“SCSI print”
• Windows XP, Windows Server 2003
“IP over 1394”, “SCSI print”
❒ Under Windows 2000, the 1394 in-
terface board can only be used
with Service Pack 1 or later. The
client cannot install the printer
driver without using an account
that has administrators access
rights.
❒ Before touching the 1394 interface
board, ground yourself by touch-
ing something metal to discharge
any static electricity. Static electric-
ity can damage the 1394 interface
board.
❒ Do not plug or unplug the 1394 in-
terface cable while installing the
printer driver.
❒ Use the 1394 interface cable that
comes with 1394 interface board.
A Check the package contains the
following:
❖ IEEE 1394 Interface Board Type B
❖ Interface Cable (6 × 6 pins)
❖ Interface Cable (6 × 4 pins)
B Turn off the power, and then un-
plug the power cable.
• Do not touch the inside of the
controller board compartment.
Doing so may cause a malfunc-
tion or a burn.
ABT009S1
GaiaP1GB_Setup-F4_FM_forPaper.book Page 49 Friday, June 3, 2005 7:50 AM
To Next Page
Loading...
Need help?
General