Attaching IEEE 802.11b Interface Unit Type H
51
3
Attaching IEEE 802.11b Interface Unit Type H
CAUTION:
Important
❒ Before touching the 802.11b inter-
face unit, touch something metal to
discharge any static electricity.
Static electricity can damage the
802.11b interface unit.
❒ Do not subject the 802.11b interface
unit to physical shocks.
A Check the contents of the package
for the following:
❖ IEEE 802.11b Interface Unit Type H
•Interface Unit
•Card
• Antenna
• Antenna Cap
B Turn off the power, and then un-
plug the power cable.
C Loosen the two screws and re-
move the cover of the 802.11b in-
terface unit installation unit.
The removed cover is not used
when installing the interface unit.
• Do not touch the inside of the
controller board compartment.
Doing so may cause a machine
malfunction or a burn.
AAL151S
ZHBP420E
ZHBP430E
AAL888S
AET091S
GaiaP1GB_Setup-F4_FM_forPaper.book Page 51 Friday, June 3, 2005 7:50 AM
To Next Page
Loading...
