Installing Options
54
3
D Fully insert the Bluetooth inter-
face unit.
E Tighten the two screws to secure
the interface unit.
F With the “INSERT” side facing
you, slowly insert the card into
the Bluetooth interface unit until
it stops.
G Press the antenna to extend it.
H Holding the antenna cap with the
two cut-off corners toward you,
fit the cap over the card.
Note
❒ After finishing installation, you
can check the Bluetooth inter-
face unit is properly installed:
Print the configuration page
from the “List/Test Print”
menu. If it is installed properly,
you will see “Bluetooth” for
“Controller Option”.
❒ If the Bluetooth interface unit is
not installed properly, reinstall it
from step
A
. If you cannot install
it properly even after attempting
reinstallation, contact your sales
or service representative.
Reference
For printing the configuration
page, see p.30 “Test Printing”.
AET094S
AET095S
AET099S
AET100S
AET101S
GaiaP1GB_Setup-F4_FM_forPaper.book Page 54 Friday, June 3, 2005 7:50 AM
To Next Page
Loading...
