DO’S AND DON’TS
Copier
General operation
S
When you use the bypass feed table while placing the original directly on the
exposure glass, lower the platen cover or optional document feeder before press-
ing the
Start
key.
S
Do not place sheets of paper or originals on the cover of the large capacity tray.
If you do, they might be fed when you make copies.
When adding toner
S
Do not incinerate toner or toner containers. Toner dust might ignite when ex-
posed to open flame.
S
Dispose of the used toner bottle according to local regulations.
S
When adding toner, do not turn off the main switch. If you do, your copy settings
are cleared.
S
Before setting the new toner bottle, shake it well, at least 5 or 6 times.
S
Do not remove the inner cap of the new toner bottle.
When removing misfed paper
S
Since some parts of the copier are supplied with high electrical voltage, touch
only the parts specified in the instructions on the sticker inside the machine’s
cover.
S
When removing misfed paper from sections B and C, use caution. The fusing unit
may be very hot. See page 4 for the position of the fusing unit.
S
Do not leave any torn scraps within the machine.
S
When clearing misfeeds, do not turn off the main switch. If you do, your copy
settings are cleared.
S
After clearing misfeeds, make sure that all units and levers are returned to their
original positions and all covers are closed.
f-eu-8
DO’S AND DON’TS
146
To Next Page
Loading...
