USE AND STORAGE OF SUPPLIES
Copy Paper
S
Copy paper of the types or in the conditions listed below are not recommended
for this copier.
•
Folded, curled, creased, or damaged paper
•
Torn paper
•
Damp paper
•
Perforated paper
•
Paper with conductive or low electrical resistance such as carbon or sliver
coating.
•
Wavy paper
•
Thermal paper, art paper
•
Thin paper that has low stiffness
S
Adhesive labels should be fed from the bypass feed table one sheet at a time.
S
OHP transparencies should be fed from the bypass feed table. You can set ten
sheets at a time. However, if misfeed or multi-feed occurs, feed them one sheet
at a time.
S
OHP transparencies should be fanned to get air between the sheets before load-
ing.
S
Translucent paper should be fed from the bypass feed table.
S
Translucent paper should be fed so that the paper grain is oriented with the
paper path.
S
Postcards should be fed from the bypass feed table. Correct any curls they might
have before loading them.
S
It is recommended to feed one post card at a time.
S
Do not touch copy paper if your fingers are wet or oily; finger prints may appear
on the copy.
S
Do not use the copy paper that has been already copied on.
S
Load paper with the copy side
down
in the 250 sheet and 500-sheet trays, and
with the copy side
up
in the large capacity tray. If copies are curled, try turning
the copy paper over in the tray. If there is no improvement, change to copy paper
with less curl.
f-eu-8
USE AND STORAGE OF SUPPLIES
151
To Next Page
Loading...
