11
4. Windows Configuration
Configuring TCP/IP
This describes how to configure Win-
dows for TCP/IP and IPP.
Configuring a Windows 98SE /
Me Computer
Follow the procedure below to con-
figure a Windows 98SE / Me compu-
ter to use TCP/IP.
A Open [Control Panel], and then
double-click the Network icon.
Make sure [TCP/IP] is selected in
the [The following network compo-
nents are installed] box on the [Con-
figuration] tab.
Note
❒ Select TCP/IP if it is not already
selected.
❒ If TCP/IP is not installed, click
[Add] on the [Configuration] tab to
install it. For details about in-
stalling TCP/IP, see Windows
98SE / Me Help.
B Click [Properties].
C Configure TCP/IP using the ap-
propriate IP address, subnet
mask, and other settings.
Check with the network adminis-
trator that the settings are correct.
Configuring a Windows 2000
Computer
Follow the procedure below to con-
figure a Windows 2000 computer to
use TCP/IP.
A On the [Start] menu, point to [Set-
tings], and then click [Network and
Dial-up Connections].
B Double-click [Local Area Connec-
tion]. On the [General] tab, click
[Properties].
C
Make sure
[
Internet Protocol (TCP/IP)
]
is selected in the [Components
checked are used by this connection]
box on the [General] tab.
Note
❒ Select TCP/IP if it is not already
selected.
❒ If TCP/IP is not installed, click
[Install] on the [General] tab to in-
stall it. For details about install-
ing TCP/IP, see Windows 2000
Help.
D Click [Properties].
E Configure TCP/IP using the ap-
propriate IP address, subnet
mask, and other settings.
Check with the network adminis-
trator that the settings are correct.
To Next Page
Loading...
