Windows Configuration
12
4
Configuring a Windows XP
Computer
Follow the procedure below to con-
figure a Windows XP computer to use
TCP/IP.
A On the [Start] menu, click [Control
Panel], and then click [Network Con-
nections].
B Click [Network Connections], and
then double-click [Local Area Con-
nection].
C On the [General] tab, click [Proper-
ties].
D
Make sure
[
Internet Protocol (TCP/IP)
]
is selected in the [This connection
uses the following items] box on the
[General] tab.
Note
❒ Select TCP/IP if it is not already
selected.
❒ If TCP/IP is not installed, click
[Install] on the [General] tab to in-
stall it. For details about install-
ing TCP/IP, see Windows XP
Help.
E Click [Properties].
F Configure TCP/IP using the ap-
propriate IP address, subnet
mask, and other settings.
Check with the network adminis-
trator that the settings are correct.
Configuring a Windows Server
2003 computer
Follow the procedure below to con-
figure a Windows Server 2003 com-
puter to use TCP/IP.
A On the [Start] menu, point to [Con-
trol Panel], point to [Network Connec-
tions], and then click [Local Area
Connection].
B On the [General] tab, click [Proper-
ties].
C
Make sure
[
Internet Protocol (TCP/IP)
]
is selected in the [This connection
uses the following items] box on the
[General] tab.
Note
❒ Select TCP/IP if it is not already
selected.
❒ If TCP/IP is not installed, click
[Install] on the [General] tab to in-
stall it. For details about install-
ing TCP/IP, see Windows
Server 2003 Help.
D Click [Properties].
E Configure TCP/IP using the ap-
propriate IP address, subnet
mask, and other settings.
Check with the network adminis-
trator that the settings are correct.
To Next Page
Loading...
