15/06/2012 MP6002/7502/9002 Technical Launch Information
28
3.7.2 SCAN TO EMAIL
Requirement: SMTP gateway and TCP/IP
Authorization SMTP
POP before SMTP
Resolution: 100dpi, 200dpi (default), 300dpi, 400dpi, 600dpi
Max e-mail address# in
hdd:
2,000 Addresses
Register group address in
hdd:
Max. 500 addresses minimum 100 addresses in one group
address
Maintain e-mail address in
hdd:
Direct input on operation panel,
web image monitor, smart net monitor
Input of destination e-mail
address via soft key:
Possible, max. 100 destinations per job
Search e-mail address in
HDD:
By name, e-mail address, folder pass, ip-fax
LDAP search: Yes
Max. address numbers per
send:
Max. 500 addresses per send *1
Address numbers per
send:
Address from HDD address book *1 Max. 500
Address directly input via soft key *1 *2 Max. 100
Address looked up via LDAP *1 *2 Max. 100
Attention: To CC, BCC
Subject: Manual input Max. 128 characters via soft key
Pre-register by
user
24 Subjects.
Max. 20 characters per a subject
BODY
MESSA
GE:
Manual input Max. 80 characters via soft key
Pre-register by
user
5 body messages. 80 characters x 5 lines per a body message
title name of the body message: max. 20 characters per a name
Preset Message: “this e-mail included attached file sent from
xxxx(machine model name).”
E-mail size (with
restriction):
128 - 102,400kb, default = 2,048kb
E-mail size (w/o
restriction):
725MB
File type: Single page tiff/jpeg, single page pdf, multi page tiff, multi page
pdf, high compression pdf
Program user setting: Yes (up to 10 programs)
Divide and send e-mail: Yes (by page or size) / no, default = yes(by size) *3
Resend: Yes / no, default = yes
*1: Address from hdd address book + address input via soft key + address looked up via
LDAP = Max.500.
*2: Address directly input via soft key + address looked up via LDAP = max. 100.
*3: If the sent file size exceeded the maximum e-mail size, it would be divided to multiple
sending. in addition, the sent files might not be accepted by the receiving side due to the
limitation in the receiving capacity at the receiver SMTP server or e-mail software setting.
To Next Page
Loading...
Need help?
General
