The default setting is Top Right.
• Adjust Stamp Position
You can adjust the position of the stamp within the available ranges shown below.
• Metric version:
"Top Left" T/B: 4-144mm, L/R: 4-144mm
"Top Centre" T/B: 4-144mm, L/R: 72-72mm
"Top Right"-T/B: 4-144mm, L/R: 4-144mm
"Centre Left"-T/B: 72-72mm, L/R: 4-144mm
"Centre"-T/B: 72-72mm, L/R: 72-72mm
"Centre Right"-T/B: 72-72mm, L/R: 4-144mm
"Bottom Left"-T/B: 4-144mm, L/R: 4-144mm
"Bottom Centre"-T/B: 4-144mm, L/R: 72-72mm
"Bottom Right"-T/B: 4-144mm, L/R: 4-144mm
• Inch version:
"Top Left"-T/B: 0.1"-5.7", L/R: 0.1"-5.7"
"Top Centre"-T/B: 0.1"-5.7", L/R: 2.8"-2.8"
"Top Right"-T/B: 0.1"-5.7", L/R: 0.1"-5.7"
"Centre Left"-T/B: 2.8"-2.8", L/R: 0.1"-5.7"
"Centre"-T/B: 2.8"-2.8", L/R: 2.8"-2.8"
"Centre Right"-T/B: 2.8"-2.8", L/R: 0.1"-5.7"
"Bottom Left"-T/B: 0.1"-5.7", L/R: 0.1"-5.7"
"Bottom Centre"-T/B: 0.1"-5.7", L/R: 2.8"-2.8"
"Bottom Right"-T/B: 0.1"-5.7", L/R: 0.1"-5.7"
• Size
You can set the size of the stamp.
The default setting is 1 X.
• Density
You can set the pattern used to print the stamp.
• Normal
The stamp is printed on the image. You cannot check which parts will overlap.
• Lighter
The image can be seen through the stamp.
• Lightest
6. Copier / Document Server Features
228
To Next Page
Loading...
