Size
You can set the size of the stamp printed in Page Numbering mode.
The default setting is Auto.
Duplex Back Page Stamping Position
You can set the position of the duplex back page number printed in Duplex mode.
The default setting is Opposite Position.
Page Numbering in Combine
You can set page numbering when using the Combine function and the Page Numbering function
together.
The default setting is Per Original.
Stamp on Designating Slip Sheet
You can select to print the page number onto slip sheets when using the Designate function set to
"Copy" and the Page Numbering function together.
The default setting is Off.
Stamp Position
Specify how each of stamp is printed.
• Stamp Position
Specify where to print the stamp.
The default setting is Top Right.
• Adjust Stamp Position
You can adjust the position of the stamp within the available ranges shown below.
• Metric version:
"Top Left"-T/B: 4-144mm, L/R: 4-144mm
"Top Centre"-T/B: 4-144mm, L/R: 72-72mm
"Top Right"-T/B: 4-144mm, L/R: 4-144mm
"Bottom Left"-T/B: 4-144mm, L/R: 4-144mm
"Bottom Centre"-T/B: 4-144mm, L/R: 72-72mm
"Bottom Right"-T/B: 4-144mm, L/R: 4-144mm
• Inch version:
"Top Left"-T/B: 0.1"-5.7", L/R: 0.1"-5.7"
"Top Centre"-T/B: 0.1"-5.7", L/R: 2.8"-2.8"
"Top Right"-T/B: 0.1"-5.7", L/R: 0.1"-5.7"
"Bottom Left"-T/B: 0.1"-5.7", L/R: 0.1"-5.7"
"Bottom Centre"-T/B: 0.1"-5.7", L/R: 2.8"-2.8"
6. Copier / Document Server Features
232
To Next Page
Loading...
Need help?
General
