automatically selected and stapled using the Mixed Sizes mode and Auto Paper Select function. Load
the paper you want to use in the paper trays beforehand. Paper sizes that can be stapled when using
the Mixed Sizes mode are as follows:
• A3 and A4
• B4 JIS and B5 JIS
• 11 × 17 and 8
1
/
2
× 11
• When the Finisher SR3010 (Type 1 and 2) is installed, even if you place different size originals in the
ADF, appropriate size of copy paper can be automatically selected and stapled using the Mixed
Sizes mode and Auto Paper Select function. Load the paper you want to use in the paper trays
beforehand. Paper sizes that can be stapled when using the Mixed Sizes mode are as follows:
• A3 and A4
• B4 JIS and B5 JIS
• 11 × 17 and 8
1
/
2
× 11
• 8
1
/
4
× 14 and 8
1
/
2
× 11
• When the Booklet Finisher SR3020 (Type 3 and 4), the Finisher SR3030 (Type 3 and 4) or the Finisher
SR790 (Type 3 and 4) is installed, even if you place different size originals in the ADF, appropriate
size of copy paper can be automatically selected and stapled using the Mixed Sizes mode and Auto
Paper Select function. Load the paper you want to use in the paper trays beforehand. Paper sizes that
can be stapled when using the Mixed Sizes mode are as follows:
• A3 and A4
• B4 JIS and B5 JIS
• 11 × 17 and 8
1
/
2
× 11
• When stapling B4 JIS , 8
1
/
2
× 14 or larger paper sizes, be sure to extend the paper support
plate of the finisher tray.
• When the number of copies exceeds tray capacity, copying stops. If this happens, remove the copies
from the shift tray, and then resume copying. For details about the number of stapled copies that can
be stacked on the shift tray, see “Paper Requirements when Using the Finisher”.
• You cannot change stapling positions during copying.
• When the original image is rotated, the staple orientation changes by 90°.
• The maximum original image size that can be rotated is as follows: Metric version: A4, Inch version:
8
1
/
2
× 11
• When using Slant, Left 2, or Top 2 with the Combine, Double Copies or Auto Reduce / Enlarge
function, "Orig. and paper orientation mismatched for Staple mode. Cancel Staple mode or change
paper orientation in tray." message may appear depending on the orientation of originals and paper
you placed. In this case, change the paper orientation.
• When Top or Bottom is selected and the paper with the same orientation as the original is not loaded,
the image is rotated and the paper with the same size and the different orientation is selected.
Finishing
89
To Next Page
Loading...
Need help?
General
