7. Set the “Lockout Release Timer” to [Active].
8. In the “Lock Out User for” field, enter the number of minutes until lockout is disabled.
9. Click [OK].
User Lockout Policy is set.
10. Click [Logout].
Unlocking a Locked User Account
A locked user account can be unlocked by the administrator or supervisor with unlocking privileges using
Web Image Monitor.
1. Open a Web browser.
2. Enter “http://(the machine's IP address or host name)/” in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is
“192.168.001.010”, you must enter it as “192.168.1.10” to connect to the machine.
The top page of Web Image Monitor appears.
3. Click [Login].
The administrator or supervisor with unlocking privileges can log on.
Enter the login user name and login password.
4. Click [Address Book].
The Address Book page appears.
5. Select the locked out user's account.
6. Click [Change].
7. Set the “Lockout” to [Inactive] under “Authentication Information”.
8. Click [OK].
9. Click [Logout].
Auto Logout
This can be specified by the machine administrator.
For details about logging on and logging off with administrator authentication, see “Logging on Using
Administrator Authentication”, “Logging off Using Administrator Authentication”.
When using user authentication management, the machine automatically logs you off if you do not use the
control panel within a given time. This feature is called “Auto Logout”. Specify how long the machine is to
wait before performing Auto Logout.
If User Authentication is Specified
103
To Next Page
Loading...
Need help?
General
