2. Enter “http://(the machine's IP address or host name)/” in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is
“192.168.001.010”, you must enter it as “192.168.1.10” to connect to the machine.
The top page of Web Image Monitor appears.
3. Click [Login].
4. Enter the login name and password of an administrator, and then click [Login].
5. Make settings as desired.
• When logging on as an administrator use the login name and password of an administrator set in the
machine. The default login name is “admin” and the password is blank.
Using Web Printing Tool
Administrative settings for GL/2 & TIFF Filter can be changed, system logs can be collected, etc. using
Web Printing Tool.
1. Open a Web browser.
2. Enter “http://(machine's address)/webprint/” in the Web browser's address bar.
Top page of Web Printing Tool appears.
3. Click the link to the administrator's page in the header area on the upperright hand of the
screen.
To change administrative settings (GL/2 & TIFF Initial Configuration) click .
To collect system logs click .
4. Enter the administrator password, and then click [OK].
5. Make setting as desired.
• When logging in to Web Printing Tool the default password is set as “admin”.
• To differentiate from the administrator password set in the machine, use a password unique to Web
Printing Tool for login.
• If the password authentication fails three times in a row, you will be returned to the Web Printing
Tool top page. To return to the login page again, click the link in the header area on the upper-right
hand of the screen.
• The password can be changed in “Change the administrator password” under the “Administrator
Password” tab on the administrator settings (GL/2& TIFF Initial Configuration) screen. Click [On] to
activate the password entry fields. The password must be 4 to 8 characters long.
• For details about Web Printing Tool, see the Web Printing Tool Help.
Administrator Authentication
43
To Next Page
Loading...
