2. Press [Change].
3. Specify the range in which [Simple (Limitation)] is applied to “Printer Job Authentication”.
You can specify the IPv4 address range to which this setting is applied, and whether or not to apply
the setting to the parallel and USB interfaces.
4. Press [Exit].
5. Press [On] for “Use Secure Connection (SSL)”, and then press [OK].
To not use secure sockets layer (SSL) for authentication, press [Off].
6. Press the [User Tools/Counter] key.
A confirmation message appears.
If you click [Yes], you will be automatically logged out.
Integration Server Authentication
93
To Next Page
Loading...
