• When using 64-bit WEP, up to 10 hexadecimal characters or five ASCll characters can be
entered. When using 128-bit WEP, up to 26 hexadecimal characters or 13 ASCll characters
can be used.
• Up to 10 or 26 hexadecimal characters and 5 or 13 ASCll characters can be entered.
• For ASCII character strings, uppercase and lowercase letters are differentiated, so be sure to
enter characters in the required case.
5. Press the [Menu] key to return to the initial screen.
6. Print a configuration page to confirm the settings.
• The WEP key can also be set using a Web browser. For details, see the Web Image Monitor Help.
• For details about printing the configuration page, see “Test Printing”, Quick Installation Guide.
Setting WPA
In the case of using WPA on a network, activate the WPA setting to be used for communication along with
WPA. Consult your network administrator for information about making authentication settings.
• For setting WPA, installing the optional HDD or the optional Data Storage Card is required.
1. Press the [Menu] key.
2. Press the [ ] or [ ] key to select [Host Interface], and then press the [OK] key.
Setting Security Method of Wireless LAN
69
To Next Page
Loading...
Need help?
General