Service Call Conditions
Summary
This printer issues an SC (Service Call) code if an error occurs on the printer. The error code can be seen
on the operation panel.
Make sure that you understand the following points;
1. All SCs are logged.
2. At first, always turn the main switch off and on if an SC code is issued.
3. First, disconnect then reconnect the connectors before you replace the PCBs, if the problem concerns
electrical circuit boards.
4. First, check the mechanical load before you replace motors or sensors, if the problem concerns a
motor lock.
5. Fusing related SCs: To prevent damage to the printer, the main printer cannot be operated until the
fusing related SC has been reset by a service representative.
• Enter the engine maintenance mode.
• Press "O.K" in "Fuser SC Reset" with engine maintenance mode, and then turn the main power
switch off and on.
Engine SC
SC 1xx (Other Error)
195
Serial Number Error
The serial number stored in the memory (EGB) is not correct.
• EEPROM defective
• EGB replaced without original EEPROM
1. Check the serial number.
2. If the stored serial number is incorrect, contact your supervisor.
Service Call Conditions
15
To Next Page
Loading...
