• If "Engine FW download completed" does not appear, the download failed. Try again. You can
also switch from an Ethernet connection to a USB connection and see if that works. If you still
cannot download the firmware, it may be necessary to change the EGB and/or the controller
board.
• If power failed during the download, try again. If you still cannot download the firmware, it may
be necessary to change the EGB and/or the controller board.
9. Turn the printer off and on.
Boot Loader Firmware
This is also listed on the configuration page, but this firmware is not updated in the field.
5. System Maintenance Reference
86
To Next Page
Loading...
