Group (Tab) Item Selections Remarks
Registration
Tray 2
Print Test Sheet
button
Sends a command to the printer to print a test
sheet.
It is disabled when tray 2 is not installed.
Adjustment
Horizontal
(-15 to +15)
step
0.34 mm per step. Range is -5 mm to +5 mm.
If the machine settings are reset to the factory
defaults, this value does not change.
Adjustment
Vertical
(-15 to +15)
step
0.24 mm per step. Range is -3.6 mm to +3.6 mm
If the machine settings are reset to the factory
defaults, this value does not change.
Registration
Bypass Tray
Print Test Sheet
button
Sends a command to printer to print a test sheet.
Adjustment
Vertical
(-15 to +15)
step
0.24 mm per step. Range is -3.6 mm to +3.6 mm
Color
Registration
Adjust button
The engine will do color registration and density
tuning automatically.
The printer will warm up automatically after this
setting is changed.
The “color registration” in User Tools includes
only a “Fine Adjustment”. In service support,
never fail to use SP mode 2 including both fine
and rough adjustment.
FW Update
button
FW update
button
This button is for updating the controller firmware.
The button for updating the engine firmware is
located in the "SP Mode 1" tab.
"*" indicates the factory default value.
Smart Organizing Monitor
31
To Next Page
Loading...
