4. Configuration
Ethernet Configuration
Make the following network settings according to the network interface you are using.
You can use SmartDeviceMonitor for Admin or a Web browser to make IP address-related settings in a
TCP/IP-capable environment.
• Configure the printer for the network using the control panel.
• The following table shows the control panel settings and their default values. These items appear in
the [Host Interface] menu.
Setting Name Value
IPv4 Settings • DHCP: On
• IPv4 Address: 011.022.033.044
• Subnet Mask: 000.000.000.000
• Gateway Address: 000.000.000.000
IPv6 Settings Stateless sett.: Active
Frame Type (NW) Auto Select
Active Protocol • IPv4: Active
• IPv6: Not Active
• NetWare: Active
• SMB: Active
• AppleTalk: Active
Ethernet Speed Auto Select
LAN Type Ethernet
• If DHCP is in use, the IP address, subnet mask, and gateway address are all set automatically.
• Make this setting only when it is necessary. See Software Guide.
53
To Next Page
Loading...
Need help?
General