9. Set [Trans. Speed] in the same way.
The factory default is [Auto]. If you need to change the transmitting speed depending on environment
you are using, select the appropriate transmitting speed.
10. Print a configuration page to confirm the settings made.
• "Printing the Test Page", Quick Installation Guide.
Setting SSID
If [Infrastructure] or [802.11 Ad hoc] is selected for [Comm. Mode], set SSID to use for transmission. Consult
your network administrator for the SSID to use.
1. In the [IEEE 802.11b] menu, press the [ ] or [ ] key to display [SSID], and then press the
[ Enter] key.
If an SSID has been set, you can check the SSID setting.
2. Press the [ ] or [ ] key to display [Enter ID], and then press the [ Enter] key.
3. Press the [ ] or [ ] key to enter characters, and then press the [ Enter] key.
The number of characters you have entered is displayed on the top right of the screen.
The characters that can be used are ASCII 0x20-0x7e (32 bytes), 16 digits.
IEEE 802.11b (Wireless LAN) Configuration
63
To Next Page
Loading...
