2. Press the [ ] or [ ] key to display [Host Interface], and then press the [ Enter] key.
3. Press the [ ] or [ ] key to display [IEEE 802.11b], and then press the [ Enter] key.
4. Press the [ ] or [ ] key to display [Comm. Mode], and then press the [ Enter] key.
5. Press the [ ] or [ ] key to select the transmission mode of IEEE 802.11b, and then press the
[ Enter] key.
The factory default is [802.11 Ad hoc].
To use an IEEE 802.11b card for which the SSID (Network Name) setting is not necessary, select [Ad
hoc].
The transmission mode of IEEE 802.11b can also be set using a Web browser. For details, see Web
browser, and "Configuring the Network Interface Board", Software Guide.
6. If [802.11 Ad hoc] or [Ad hoc] is selected for [Comm. Mode], set the channel to use for
transmission.
Confirm the network administrator for the channel to use.
7. In the [IEEE 802.11b] menu, press the [ ] or [ ] key to display [Channel], and then press
the [ Enter] key.
8. Press the [ ] or [ ] key to set the channel, and then press the [ Enter] key.
4. Configuration
62
To Next Page
Loading...
