Ricoh Aficio SP4100N - Making Network Settings for Using Netware

5. Press the [ ] or [ ] key to display [DHCP], and then press the [ Enter] key.
6. Press the [ ] or [ ] key to select [On] or [Off], and then press the [ Enter] key.
The address will be detected by the printer.
The default setting is [On].
7. Press the [Online] key.
The initial screen appears.
8. Print a configuration page to confirm the settings made.
• "Printing the Test Page", Quick Installation Guide.
Making Network Settings for Using NetWare
If you use NetWare, select the frame type for NetWare.
Select one of the items below if necessary.
• Auto Select (Default)
• Ethernet II
• Ethernet 802.2
• Ethernet 802.3
• Ethernet SNAP
• Usually, use the default setting ([Auto Select]). When you first select [Auto Select], the frame type
detected by the printer is adopted. If your network can use more than two frame types, the printer
may fail to select the correct frame type if [Auto Select] is selected. In this case, select the appropriate
frame type.
Ethernet Configuration
57
4