Placing Originals
15
1
Placing Originals in the Auto
Document Feeder
Settings should be made in the fol-
lowing situations:
❖ When placing originals consisting of
more than 50 pages:
p.15 “Batch”
❖ When placing originals one by one:
p.16 “SADF”
❖ When placing same width originals of
different sizes:
p.16 “Mixed size”
❖ When placing custom size originals:
p.17 “Placing custom size origi-
nals”
Note
❒
Do not stack originals above the lim-
it mark on the side guide of the ADF.
❒ The last page should be on the bot-
tom.
❒ Be sure not to block the sensor or
load the original untidily.. Doing
so may cause the machine to detect
the size of the scanned image in-
correctly or display a paper mis-
feed message. Also, be sure not to
place originals or other objects on
the top cover. Doing so may cause
a malfunction.
1. Sensors
A Set the document guide to the
original size.
B Place the aligned originals face
up into the ADF.
1. Limit mark
2. Document guide
Note
❒ Straighten any curls in the orig-
inals before placing them in the
ADF.
❒ To prevent multi-sheet feeds,
fan the originals before placing
them in the ADF.
❒ Place the originals squarely.
Batch
When using Batch, the machine cop-
ies originals of more than 50 pages as
a single document, even if placed in
the ADF in parts.
Important
❒
Place special originals, such as trans-
lucent
paper, one by one.
ZEWH210E
ZLFH050E
To Next Page
Loading...
