Basic Procedure
21
2
Job Preset
You can make settings for the next
copy job while copying is in progress.
If a long copy job is in progress and
you do not want to wait for it to finish,
you can use this function to make set-
tings for the next copy job in advance.
When the current copy job finishes,
the next job starts automatically.
A
Press
[
NextJob
]
when "
Copying...
"
appears.
B Make settings for the next copy
job.
C Place the originals in the ADF,
and then press the {Start} key.
All originals are scanned.
D Press [To "Printing"].
The initial copy display appears.
Following the current copy job, the
next job starts automatically.
Note
❒ You can switch the display to
the current copy job by pressing
[To "Printing"]. You can switch
the display to the preset job by
pressing [To "Reserving"].
To Next Page
Loading...
