Replacing Consumables and Maintenance Kit
40
2
F Replace the new fusing unit into
the printer.
G Push the lock levers of the fusing
unit down until it clicks.
H Insert the rear cover to the inside
grooves on both sides of the print-
er in a horizontal direction.
I Close the rear cover.
J Print a configuration page to con-
firm that the printer works prop-
erly.
Reference
For more information about
printing the configuration page,
see “Test Printing”, Setup
Guide.
Replacing the fusing unit with the
duplex unit attached
A Push down the lever on the right
side of the duplex unit ( ), and
then pull it out until it stops ( ).
AGN008S
AGN009S
ZKGX221E
AGN005S
ZKGX320E
KirP4GB_Mainte-F6_FM_forPaper.book Page 40 Thursday, May 12, 2005 11:48 AM
To Next Page
Loading...
