Cleaning the Printer
44
3
Cleaning the Friction Pad
If the friction pad is dirty, a multi-
feed or a misfeed might occur. In this
case, clean the pad as follows:
A Lift the paper tray slightly, and
then pull it out until it stops. Lift
the front side of the tray, and then
pull it out of the printer.
B Place the tray on a flat surface.
When there is paper in the tray,
remove paper.
C Wipe the brown part of the fric-
tion pad with a soft damp cloth.
Then, wipe it with a dry cloth to
remove the water.
Important
❒ Do not use chemical cleaner or
organic solvent such as thinner
or benzene.
D Load paper into the paper tray
with the print side up. Carefully
slide the paper tray into the print-
er until it stops.
Important
❒ Do not slide the paper tray in
with force. If you do, the front
and side guides might move.
Note
❒ If misfeeds or multi-feeds of pa-
per occur after cleaning the fric-
tion pad, contact your sales or
service representative.
❒ Follow the same procedure to
clean the friction pad of the op-
tional paper feed unit and the
envelope feeder unit.
ZKGY140E
TS3Y250E
ZKGY150E
KirP4GB_Mainte-F6_FM_forPaper.book Page 44 Thursday, May 12, 2005 11:48 AM
To Next Page
Loading...
